Overview
HSM3WIFI is a temporary USB Wi-Fi programming accessory for PowerSeries Pro control panels.
Official source
- Product page: DSC HSM3WIFI (ID 2656)
Supported host panels
- HS3032
- HS3128
- HS3248
Deployment intent
Use for temporary commissioning/programming sessions only — connect USB, configure the panel over Wi-Fi from a mobile device or PC, then remove before leaving site.
Product status
DSC has published a discontinuation notice for HSM3WIFI — verify replacement programming options (hardwired IP, dealer tools) for new Pro installs.
At a glance
| Detail | Value |
|---|---|
| Connection | USB to Pro panel rear port |
| Panel trouble while connected | USB Wi-Fi Connected (expected) |
| Permanent install | Not supported — remove at handoff |
| Discontinued | Verify alternate programming path for new installs |
Installation Notes
Usage workflow
- Connect HSM3WIFI to USB on HS3032, HS3128, or HS3248 only.
- Panel displays USB Wi-Fi Connected trouble — expected while adapter is inserted.
- Join the panel Wi-Fi network from installer laptop/tablet; run programming software.
- Save all programming changes and verify panel responds on Corbus keypads.
- Export programming backup if site policy requires.
- Remove HSM3WIFI before leaving — trouble must clear for turnover.
- Confirm monitoring trouble clear after removal on live accounts.
Site handoff requirement
HSM3WIFI is not permanently installed — store in installer kit after commissioning.
Discontinuation note
Plan IP/DLS/cloud programming path for future Pro service visits.
Before each service visit
- Confirm panel model is Pro (HS3032/3128/3248) before connecting USB.
- Bring alternate programming method if adapter fails — product is discontinued.