Overview
HSM3WIFI is a temporary USB Wi-Fi programming accessory for PowerSeries Pro control panels.
Official source
- Product page: DSC HSM3WIFI (ID 2656)
Supported host panels
- HS3032
- HS3128
- HS3248
Deployment intent
Use for temporary commissioning/programming sessions only — connect USB, configure the panel over Wi-Fi from a mobile device or PC, then remove before leaving site.
Product status
DSC has published a discontinuation notice for HSM3WIFI — verify replacement programming options (hardwired IP, dealer tools) for new Pro installs.
At a glance
| Detail | Value |
|---|---|
| Connection | USB to Pro panel rear port |
| Panel trouble while connected | USB Wi-Fi Connected (expected) |
| Permanent install | Not supported — remove at handoff |
| Discontinued | Verify alternate programming path for new installs |
FAQs
Can this stay plugged in permanently?
No — temporary commissioning only; remove before leaving site.
Why do I see "USB Wi-Fi Connected" trouble?
Normal while adapter is inserted — indicates USB accessory detected.
Is this still an active product?
DSC published a discontinuation notice — plan alternate Pro programming methods for new installs.
Does it add wireless sensors?
No — Wi-Fi is for installer programming access only, not end-user sensor network.
Will monitoring flag this trouble?
Yes — central station may see trouble while USB adapter is connected; clear before turnover.
What replaces HSM3WIFI for new Pro sites?
Hardwired IP path, DLS via communicator, or current dealer cloud commissioning tools.
Does it affect Corbus devices while connected?
No Corbus address consumed — only USB status trouble while inserted; Corbus keypads operate normally.