Overview
IQ Remote — wireless color touchscreen secondary controller for arming, disarming, and status on IQ Panel systems.
On IQ Panel systems, wireless devices are supervised zones on the panel — tamper, low battery, and missing signals appear as trouble conditions that may block arming depending on panel programming.
At a Glance
| Specification | Details |
|---|---|
| Role | Wireless touchscreen remote |
| Wireless | PowerG or panel-specific link — verify SKU |
| Power | Battery / charging per manual |
What This Device Does Well
Provides reliable supervised status at the panel and Alarm.com when installed, enrolled, and range-tested correctly.
Before You Service or Replace One
- Sensor SKU — PowerG S-Line vs IQ Card legacy vs hardwire module.
- Panel online — resolve panel AC/comms trouble before blaming sensor.
- Range — sensor placement or add IQ Remote as repeater path where supported for distant zones.
- Battery type — use listed cell; replace all batteries in multi-cell devices.
- Tamper — cover fully closed before declaring hardware fault.
Official Sources
- Qolsys product page
- Qolsys TSB # 230623 - IQ Remote - End of Life Dated 06/23/23
- Qolsys IQ Remote - Quick Guide Dated 11/2018
- Qolsys TSB190116 - IQ Remote End of Life
Use official Qolsys install PDFs and install guides for exact wiring, enrollment, and firmware — specifications vary by SKU and region.
FAQs
Why does my zone show trouble?
Most common: low battery, tamper open, out of range, or wrong sensor type for the panel receiver (PowerG vs legacy 319/345 MHz sensors).
How do I replace a sensor?
Delete old zone in installer programming, enroll replacement using Learn mode, and test walk test at final location.
Will Alarm.com show this device?
When the panel has active interactive service, enrolled zones appear in the Alarm.com app with status matching the panel.
Where is official documentation?
- Qolsys product page
- Qolsys TSB # 230623 - IQ Remote - End of Life Dated 06/23/23
- Qolsys IQ Remote - Quick Guide Dated 11/2018
- Qolsys TSB190116 - IQ Remote End of Life
Primary reference: IQ Remote user and install guide
How do I test after installation?
Use panel walk test, zone status, and (if monitored) central station test per dealer procedure.
Can I mix PowerG and 319/345 MHz legacy sensors?
PowerG needs IQ Panel/H hub; 319/345 needs IQ Card 319/345 installed transceiver hardware — they do not enroll on the standard 345 MHz receiver alone.
Why does my zone show trouble?
Most common: low battery, tamper open, out of range, or wrong sensor type for the panel receiver (PowerG vs legacy 319/345 MHz sensors).
How do I replace a sensor?
Delete old zone in installer programming, enroll replacement using Learn mode, and test walk test at final location.
Will Alarm.com show this device?
When the panel has active interactive service, enrolled zones appear in the Alarm.com app with status matching the panel.
Where is official documentation?
- Qolsys product page
- Qolsys TSB # 230623 - IQ Remote - End of Life Dated 06/23/23
- Qolsys IQ Remote - Quick Guide Dated 11/2018
- Qolsys TSB190116 - IQ Remote End of Life
Primary reference: IQ Remote user and install guide
How do I test after installation?
Use panel walk test, zone status, and (if monitored) central station test per dealer procedure.
Can I mix PowerG and 319/345 MHz legacy sensors?
PowerG needs IQ Panel/H hub; 319/345 needs IQ Card 319/345 installed transceiver hardware — they do not enroll on the standard 345 MHz receiver alone.