Qolsys IQ Keypad-PG – IQ Error Codes & Status

IQ Keypad PG — PowerG wireless keypad for arming/disarming and status away from the main panel.

On IQ Panel systems, wireless devices are supervised zones on the panel — tamper, low battery, and missing signals appear as trouble conditions that may block arming depending on panel programming.

At a Glance

What This Device Does Well

Provides reliable supervised status at the panel and Alarm.com when installed, enrolled, and range-tested correctly.

Before You Service or Replace One

• Sensor SKU — PowerG S-Line vs IQ Card legacy vs hardwire module.
• Panel online — resolve panel AC/comms trouble before blaming sensor.
• Range — sensor placement or add IQ Remote as repeater path where supported for distant zones.
• Battery type — use listed cell; replace all batteries in multi-cell devices.
• Tamper — cover fully closed before declaring hardware fault.

Official Sources

• Qolsys product page
• IQ Keypad Data Sheet NA New
• IQ Keypad Installation Manual FINAL 1
• IQ Keypad Quick Guide FINAL
• IQ Keypad User Guide FINAL
• Limited Warranty V2
• General EULA

Use official Qolsys install PDFs and install guides for exact wiring, enrollment, and firmware — specifications vary by SKU and region.

IQ Panel systems report faults on the panel and keypad status screens, zone list, and Alarm.com (when interactive service is active) — not as a single universal numeric code list across all models.

How to read status

1. Open panel status or installer menu → zones / troubles.
2. Note zone number, trouble type (open, tamper, low battery, missing, cell fail).
3. Cross-check Alarm.com device list if the account is interactive.
4. For cell issues, run installer communication test before replacing sensors.

Common trouble indicators

Installer programming reference

Panel actions (typical)

Source: IQ Keypad PG installation guide; Qolsys official resources linked in this product folder manifest.