Overview
This catalog entry is a PowerSeries Neo control panel (Alarm.com bundle listing), not a communicator module. Communicators compatible with these panels are listed separately (TL280, TL880, 3G8080, etc.).
Reporting path
Control panel (miscategorized)
At a Glance
| Detail | Value |
|---|
| Product type | Alarm communicator / reporting module |
|---|
| Model family (HS2016, HS2032, HS2064, HS2128) | See label and install manual |
|---|
| Reporting path | Control panel (miscategorized) |
|---|
| Primary manual | HS2016–HS2128 Installation Guide v1.35 |
|---|
| Region / listing notes | See Neo control panel listings in control-panels category |
|---|
Before You Install or Replace One
- Confirm exact model number on the communicator label matches the install manual.
- Verify host panel family — Keybus PowerSeries, Neo Corbus, MAXSYS Combus, IMPASSA integrated, or universal dialer-capture are not interchangeable.
- Confirm monitoring receiver and account accept this communicator format (Contact ID, SIA, IP, cellular).
- Check carrier/network generation (3G sunset, LTE band, Ethernet path) for your region.
- Add communicator current draw to panel battery standby calculation where the module loads from panel bus power.
Official Sources
- Product page: DSC PowerSeries Neo Control Panels (ID 2574)
- HS2016–HS2128 Installation Guide v1.35 — DSC official documentation
Installation Notes
Follow HS2016–HS2128 Installation Guide v1.35 for wiring, mounting, enrollment, and receiver programming. Summary below — not a substitute for the full manual.
Pre-install checklist
- Match communicator SKU to host panel family (see compatible-peripherals.md).
- Plan mounting location — metal cabinets, underground rooms, and long coax runs affect cellular/IP performance.
- Reserve panel bus power or external power per manual; update battery calculation chart.
- Confirm monitoring account and receiver are provisioned before final test.
Typical install sequence
- Mount communicator (or PCL-422 remote mount if used) per manual clearances.
- Wire power and data: Corbus/Keybus homerun, dialer Tip/Ring, or Ethernet as applicable.
- Enroll module in panel programming (Neo/Pro
[902], PowerSeries alt-comms section, IMPASSA[382]/[401]as applicable).
- Program reporting codes, account, and path priority (primary/backup for dual-path).
- Register with central station / Alarm.com / T-Link receiver.
- Run end-to-end communication test and document signal levels.
Regional notes
See Neo control panel listings in control-panels category
Source: HS2016–HS2128 Installation Guide v1.35 (DSC official documentation).