Overview
ICON hardwired keypads (HS2ICON/HS2ICN/HS2LCD-ICON-RF) combine icon zone display with optional built-in PowerG transceiver and prox (P) variants on Neo Corbus.
Panel bus / link type
Corbus (Neo) with optional PowerG transceiver
At a Glance
| Detail | Value |
|---|---|
| Product type | Alarm keypad / operator interface |
| Model family (HS2ICON, HS2ICN, HS2LCD-ICON-RF, HS2LED) | See label and install manual |
| Bus / wireless link | Corbus (Neo) with optional PowerG transceiver |
| Primary manual | HS2LCD-ICON-RF Installation Manual; HS2LED/HS2ICON Installation Sheet |
| Region / listing notes | RF suffix = integrated PowerG — verify Neo firmware supports transceiver |
Before You Install or Replace One
- Confirm exact model number on the keypad label matches the install manual.
- Verify host panel family — Keybus PowerSeries, Neo Corbus, MAXSYS Combus, and IMPASSA wireless are not interchangeable.
- Plan unique keypad address or wireless enrollment — duplicates cause bus collisions or offline devices.
- Check partition assignment (global vs partition keypad) for multi-partition sites.
- Include keypad current draw in panel AUX / Corbus / battery standby calculations.
Official Sources
- Product page: DSC ICON Hardwired Keypad (ID 2449)
- HS2LCD-ICON-RF Installation Manual; HS2LED/HS2ICON Installation Sheet — DSC official documentation
Troubleshooting
Start with host panel family, then keypad model, then bus vs wireless link.
Quick diagnostic flow
- Confirm keypad model matches HS2LCD-ICON-RF Installation Manual; HS2LED/HS2ICON Installation Sheet.
- Verify host panel is on the supported list in compatible-peripherals.md.
- Check power: panel AC/battery healthy before blaming keypad.
- Read troubles at keypad with **
[*, 2]** or trouble LED. - Verify address / enrollment — wired:
[013]Keybus or[902]Corbus; wireless: enroll window and transceiver online. - Test with known-good user code on assigned partition.
Wiring / bus
- Keybus: homerun, polarity, termination; one bad keypad can drag bus if shorted.
- Corbus/Combus: homerun from panel module; check AUX/Corbus voltage under load.
- Wireless: battery, range, antenna, transceiver supervision on panel first.
ICON-RF service
- Do not exceed Neo PowerG device limits when using ICON-RF as transceiver.
- ICON display is not full alpha message — zone text truncated vs HS2LCD.
ICON-RF service
- Enroll PowerG sensors only after ICON-RF transceiver shows online in DLS.
- Do not exceed Neo PowerG device count when using keypad-integrated transceiver.
After keypad replacement
Re-assign address, partition visibility, and user PINs per manual — new keypad does not inherit old device programming automatically.
Source: HS2LCD-ICON-RF Installation Manual; HS2LED/HS2ICON Installation Sheet; host panel installation guide keypad sections.