Overview
Ring sensor — reports status to Ring Alarm through the Z-Wave mesh managed by your Base Station.
On Ring Alarm, this device is a supervised Z-Wave peripheral — status appears under Device Health in the Ring app, and faults can block arming depending on mode settings.
At a Glance
| Specification | Details |
|---|---|
| Wireless | Z-Wave to Ring Alarm hub |
| Management | Ring app enrollment and Device Health |
| Power | Battery or wired per model |
| Supervision | Offline / Tampered / Low Battery in app |
What This Device Does Well
Provides reliable status reporting and user-facing alerts through the Ring app when installed and enrolled correctly.
Before You Service or Replace One
- Generation — Gen 1 vs Gen 2 vs 3rd gen — battery type and reset steps differ.
- Hub online — Base Station must show connected in app before diagnosing sensor.
- Range — distant devices may need Range Extender, not a new sensor.
- Tamper — cover fully closed before declaring hardware fault.
- Monitoring mode — Practice/disarmed modes affect whether alarms dispatch.
Official Sources
- https://ring.com/support/articles/9ue37/Installing-sump-pump-monitor
- https://ring.com/support/articles/im4mx/safety-compliance-sump-pump-monitor
- https://ring.com/support/products/accessories/sump-pump-monitor?page=1
Use official Ring support articles for reset procedures, battery types, LED patterns, and regional availability — Ring updates app flows frequently.
Installation Notes
Follow Official Ring support article for this sensor model and the official support links in this product folder for mounting, power, and enrollment.
Pre-install checklist
- Verify Ring Alarm vs camera/doorbell ecosystem — wrong product category cannot enroll on hub.
- Confirm Ring app on latest version; owner account available for setup.
- Plan device name and room in app for service clarity.
- For monitored locations: verify alarm permit and emergency contact list current.
- Have replacement batteries or transformer spec confirmed before truck roll.
Typical install sequence
- Set up Base Station / Alarm Pro first if this is an alarm Z-Wave device.
- Mount hardware per official template — drill, adhesive, or screw as specified.
- Insert battery / connect power; remove pull tab if present.
- Add Device in Ring app; scan QR or follow in-app prompts.
- Complete placement test (motion, contact gap, outdoor comm test) at final location.
- Arm/disarm test or Live View test; confirm events in app history.
Power and connectivity reference
| Product type | Power | Network |
|---|---|---|
| Alarm hub | AC + backup battery | Wi-Fi and/or Ethernet |
| Z-Wave sensor/siren/keypad | Battery or AC per model | Z-Wave to hub |
| Range Extender | Wall outlet | Z-Wave repeater |
| Camera / doorbell | Battery, plug, wired, PoE | Wi-Fi |
| Chime Pro | Wall outlet | Wi-Fi extender for Ring devices |
Source: Official Ring support article for this sensor model (Ring official documentation).