Overview
Z-Wave module or device — dimmer, switch, outlet, or panel Z-Wave radio add-on for home automation on supported Honeywell hosts.
On Honeywell systems, wireless devices are supervised zones on the panel — tamper, low battery, and missing signals appear as trouble conditions that may block arming depending on panel programming.
At a Glance
| Specification | Details |
|---|---|
| Protocol | Z-Wave / Z-Wave Plus |
| Enrollment | Exclude from prior hub before add |
What This Device Does Well
Provides reliable supervised status at the panel and Total Connect 2.0 when installed, enrolled, and range-tested correctly.
Before You Service or Replace One
- Sensor SKU — 5800 Series one-way vs SiX two-way encrypted vs hardwired.
- Panel online — resolve panel AC/cell trouble before blaming sensor.
- Range — 5800RP repeater or move 5881EN/6160RF receiver path for distant zones.
- Battery type — use listed cell; replace all batteries in multi-cell devices.
- Tamper — cover fully closed before declaring hardware fault.
Official Sources
- Resideo product page
- L5210 End user Commercial Sell Sheet (English)
- LYNX Touch 5210 Data Sheet (English)
- LTE Family Data Sheet (English)
- Getting the Most Out of Your Security System Residential (English)
- Getting the Most Out of Your Security System Commercial (English)
- Wireless Systems: The LYNX Family At-A-Glance Brochure (English)
- Total Connect Compatibility Chart (English)
- LYNX Touch Open the Door to Security and Convenience Brochure (English)
- L5210 End user Commercial Sell Sheet (French)
- LYNX Touch 5210 Data Sheet (French)
- LTE Family Data Sheet (French)
Use official Resideo install PDFs and install guides for exact wiring, enrollment, and firmware — specifications vary by SKU and region.
Installation Notes
Follow Z-Wave enrollment guide and the official resource links in this product folder for mounting, wiring, and enrollment.
Pre-install checklist
- Confirm panel model (VISTA/Lynx/ProSeries/Lyric) and encryption requirements.
- Verify dealer cell account and module SKU before cell install.
- Document installer code and existing zone map for takeover jobs.
- Plan antenna routing (ANT5XL) when panel location has poor cell RSSI.
- Have listed batteries and tools for sensor mounts before enrollment.
Typical install sequence
- Mount and power panel; apply firmware updates per dealer bulletin.
- Install cell module and run communication test / Total Connect 2.0 activation.
- Enroll wireless sensors via installer Learn mode; label zones.
- Include Z-Wave devices after excluding from any prior hub.
- Install 5800RP repeater or optimize receiver placement before fringe 5800 sensors.
- Run walk test, user code training, and central station test if monitored.
Z-Wave enrollment
- Exclude device from prior controller before inclusion on Honeywell panel.
- Perform inclusion within 3 ft of panel when manual recommends proximity.
- Name device clearly in programming for Total Connect 2.0 automation rules.
Power and connectivity reference
| Product type | Power | Network / RF |
|---|---|---|
| VISTA/Lynx/ProSeries/Lyric panel | AC + backup battery | 5800 receiver; ECP keypads; AlarmNet LTE/IP |
| Wireless sensor | Battery per SKU | 345 MHz 5800 Series; SiX on ProSeries/Lyric |
| Cell module | Panel-powered | LTE to dealer / Total Connect 2.0 |
| ECP keypad | Panel bus power | ECP to VISTA |
| Z-Wave module | Mains or battery per device | Z-Wave to panel |
Source: Z-Wave enrollment guide (Resideo official documentation).