Overview
5800 Series PIR — wireless motion detector (5800PIR, 5800PIR-COMBO, etc.) for interior intrusion detection on 345 MHz one-way mesh.
On Honeywell systems, wireless devices are supervised zones on the panel — tamper, low battery, and missing signals appear as trouble conditions that may block arming depending on panel programming.
At a Glance
| Specification | Details |
|---|---|
| Detection | Passive infrared motion |
| Wireless | 345 MHz 5800 Series |
| Pet immunity | Model-specific — verify install guide |
| Power | Listed lithium battery |
What This Device Does Well
Provides reliable supervised status at the panel and Total Connect 2.0 when installed, enrolled, and range-tested correctly.
Before You Service or Replace One
- Sensor SKU — 5800 Series one-way vs SiX two-way encrypted vs hardwired.
- Panel online — resolve panel AC/cell trouble before blaming sensor.
- Range — 5800RP repeater or move 5881EN/6160RF receiver path for distant zones.
- Battery type — use listed cell; replace all batteries in multi-cell devices.
- Tamper — cover fully closed before declaring hardware fault.
Official Sources
Use official Resideo install PDFs and install guides for exact wiring, enrollment, and firmware — specifications vary by SKU and region.
Installation Notes
Follow 5800 PIR installation guide and the official resource links in this product folder for mounting, wiring, and enrollment.
Pre-install checklist
- Confirm panel model (VISTA/Lynx/ProSeries/Lyric) and encryption requirements.
- Verify dealer cell account and module SKU before cell install.
- Document installer code and existing zone map for takeover jobs.
- Plan antenna routing (ANT5XL) when panel location has poor cell RSSI.
- Have listed batteries and tools for sensor mounts before enrollment.
Typical install sequence
- Mount and power panel; apply firmware updates per dealer bulletin.
- Install cell module and run communication test / Total Connect 2.0 activation.
- Enroll wireless sensors via installer Learn mode; label zones.
- Include Z-Wave devices after excluding from any prior hub.
- Install 5800RP repeater or optimize receiver placement before fringe 5800 sensors.
- Run walk test, user code training, and central station test if monitored.
5800 PIR placement
- Mount per manual height — typically wall mount with clear view of walk area.
- Set pet immunity per model (33 lb vs 55 lb on PIR1) and temperature limits.
- Avoid HVAC vents, sunny windows, and moving curtains.
Power and connectivity reference
| Product type | Power | Network / RF |
|---|---|---|
| VISTA/Lynx/ProSeries/Lyric panel | AC + backup battery | 5800 receiver; ECP keypads; AlarmNet LTE/IP |
| Wireless sensor | Battery per SKU | 345 MHz 5800 Series; SiX on ProSeries/Lyric |
| Cell module | Panel-powered | LTE to dealer / Total Connect 2.0 |
| ECP keypad | Panel bus power | ECP to VISTA |
| Z-Wave module | Mains or battery per device | Z-Wave to panel |
Source: 5800 PIR installation guide (Resideo official documentation).