Overview
DSC power supply, transformer, or battery accessory — supports panel or bus device current requirements.
Product type
Module / accessory
At a glance
| Detail | Value |
|---|---|
| Category | Module / accessory |
| Primary manual | Power accessory installation manual |
| Install scope | Premises panel or bus device |
| Supervision | Panel trouble display when faulted |
What this device does in the system
Extends panel capacity (zones, outputs, wireless, power, or reporting) — plan bus address, current draw, and device limits before install.
Before you install or replace one
- Confirm exact model number on the label matches the install manual.
- Verify host panel or system family — Keybus, Corbus, Combus, PowerG, MX, or 433 MHz are not interchangeable.
- Check device limits on the panel/receiver before adding zones, sirens, or credentials.
- Include current draw in power budget calculations for modules, receivers, and keypads.
- For wireless: test RF at the mounted location, not only on the bench.
Official sources
- Product page: DSC PowerSeries Pro - HSM3350 Supervised 3 Amp Power Supply (ID 2658)
- Power accessory installation manual — DSC official documentation
Compatible Peripherals
This page lists which panels and systems this product works with — not unrelated sensors or keypads.
Host compatibility
| Host system | How it connects |
|---|---|
| Panel family per manual | Auxiliary or standalone power per sizing table |
Not compatible / common mistakes
- Undersized transformer for total Keybus/Corbus load
Replacement guidance
- Match model, frequency, and bus type to the removed device.
- Re-enroll wireless devices after replacement — ESN/serial changes with new hardware.
- Document zone/siren/device number for monitoring station handoff.
Source: Power accessory installation manual (DSC official documentation).