Overview
This catalog entry is a PowerSeries Neo control panel, not a keypad. Operator interfaces are separate HS2LCD, ICON, or HS2TCH products.
Recommended keypads for this panel
Recommended operator keypads for Neo: HS2LCD (hardwired LCD), ICON-RF (icon + optional PowerG), HS2TCHP (7-inch touchscreen). Each requires separate Corbus enrollment at [902].
Panel bus / link type
N/A — control panel listing
At a Glance
| Detail | Value |
|---|---|
| Product type | Alarm keypad / operator interface |
| Model family | See label and install manual |
| Bus / wireless link | N/A — control panel listing |
| Primary manual | PowerSeries Neo Install Guide |
| Region / listing notes | Miscategorized under keypads in DSC CMS |
Before You Install or Replace One
- Confirm exact model number on the keypad label matches the install manual.
- Verify host panel family — Keybus PowerSeries, Neo Corbus, MAXSYS Combus, and IMPASSA wireless are not interchangeable.
- Plan unique keypad address or wireless enrollment — duplicates cause bus collisions or offline devices.
- Check partition assignment (global vs partition keypad) for multi-partition sites.
- Include keypad current draw in panel AUX / Corbus / battery standby calculations.
Official Sources
- Product page: DSC PowerSeries Neo Security Control Panel (ID 2441)
- PowerSeries Neo Install Guide — DSC official documentation
Installation Notes
Follow PowerSeries Neo Install Guide for mounting, wiring, addressing, and enrollment. Summary below — not a substitute for the full manual.
Pre-install checklist
- Match keypad SKU to host panel family (see compatible-peripherals.md).
- Select mounting height and tamper-secure back box per local code.
- Reserve bus power or confirm wireless transceiver capacity on panel.
- Plan partition and global keypad roles for multi-partition installs.
Typical install sequence
- Mount keypad back box and pull bus or confirm wireless coverage at location.
- Wire Keybus/Corbus homerun or begin wireless enrollment per manual.
- Assign keypad address in panel programming (
[013]PowerSeries,[902]Neo/Pro, DLS for MAXSYS). - Set partition assignment and display options.
- Test arming, disarming, trouble display, and prox/RF features if equipped.
- Document address, partition, and installer access for service handoff.
This is not a keypad install
Do not mount this SKU as an operator interface — it is the Neo control board. Install per Neo Installation Guide, then add at least one HS2LCD/ICON/HS2TCH keypad on Corbus for local arming and [*, 2] trouble access.
Regional notes
Miscategorized under keypads in DSC CMS
Source: PowerSeries Neo Install Guide (DSC official documentation).