DSC Loop Isolator Module Error Codes & Status

DSC module or accessory — expander, receiver, relay, interface, or power device for supported panel families.

Product type

Module / accessory

At a glance

What this device does in the system

Extends panel capacity (zones, outputs, wireless, power, or reporting) — plan bus address, current draw, and device limits before install.

Before you install or replace one

• Confirm exact model number on the label matches the install manual.
• Verify host panel or system family — Keybus, Corbus, Combus, PowerG, MX, or 433 MHz are not interchangeable.
• Check device limits on the panel/receiver before adding zones, sirens, or credentials.
• Include current draw in power budget calculations for modules, receivers, and keypads.
• For wireless: test RF at the mounted location, not only on the bench.

Official sources

• Product page: DSC Loop Isolator Module (ID 68)
• Official DSC installation manual — DSC official documentation

Module faults appear on panel trouble display ([*, 2] where supported):

• Module Missing / Supervision — bus wiring, address, enrollment
• AUX Power Trouble — module or keypad load exceeded budget
• Output Fault — PGM/bell wiring or EOL supervision

Common status / trouble indicators

Keypad commands (host panel)

Enrollment / supervision notes

• Most faults after install are enrollment, addressing, or power — not defective hardware.
• Wireless devices: confirm receiver/transceiver online before replacing the device.
• Modules: verify bus address unique and wiring homerun correct.
• Life-safety sensors: verify fire/CO zone type and monitoring path separately from burglary.

Source: Official DSC installation manual; host panel or system install manual.