DSC It’s Time to Swap & Save! Error Codes & Status

DSC marketing campaign catalog entry — not a field-installable product. Use official product pages for actual hardware.

Product type

Catalog / campaign

At a glance

What this device does in the system

Extends panel capacity (zones, outputs, wireless, power, or reporting) — plan bus address, current draw, and device limits before install.

Before you install or replace one

• Confirm exact model number on the label matches the install manual.
• Verify host panel or system family — Keybus, Corbus, Combus, PowerG, MX, or 433 MHz are not interchangeable.
• Check device limits on the panel/receiver before adding zones, sirens, or credentials.
• Include current draw in power budget calculations for modules, receivers, and keypads.
• For wireless: test RF at the mounted location, not only on the bench.

Official sources

• Product page: DSC It’s Time to Swap & Save! (ID 1442)
• DSC product change / campaign bulletin — DSC official documentation

This listing is a DSC marketing campaign (DSC It’s Time to Swap & Save! (ID 1442)) — not installable alarm hardware. It does not appear on panel trouble menus and has no zone, device, or LED fault codes.

If you are troubleshooting an installed system

1. Read the active trouble on the premises keypad or app ([*, 2] on PowerSeries where supported).
2. Note the model number on the device label (communicator, keypad, sensor, module).
3. Open that product's page on DSC.com or AlarmSystemHelp — not this campaign bulletin.

Campaign vs product documentation

Source: DSC product change / campaign bulletin; DSC It’s Time to Swap & Save! (ID 1442)