Overview
DMP fire/life-safety device — smoke, heat, or CO wireless/hardwire life-safety input for listed DMP fire configurations.
Life-safety devices have stricter placement and testing requirements than burglary sensors. Follow NFPA/local code, use professional monitoring where required, and never substitute takeover modules for fire or CO hardwire.
At a Glance
| Specification | Details |
|---|---|
| Life safety | Follow NFPA/local code and monitoring requirements |
| Wireless | 1100 Series or hardwire per SKU |
What This Device Does Well
Provides reliable supervised status at the panel and central station / Dealer Admin when installed, enrolled, and range-tested correctly.
Before You Service or Replace One
- Device age — smoke/CO sensors expire; replace per label date.
- Zone type — fire vs burglary programming differs; do not bypass without authority.
- FireFighter placement — acoustic path to standalone smoke alarms.
- Monitoring — central station fire test procedures for monitored accounts.
Official Sources
Use official DMP install PDFs and install guides for exact wiring, enrollment, and firmware — specifications vary by SKU and region.
Installation Notes
Follow DMP fire device installation guide and the official resource links in this product folder for mounting, wiring, and enrollment.
Pre-install checklist
- Confirm panel model (XR/XT/X1) and 1100 Series vs hardwire zone type.
- Verify dealer cell account and module SKU before cell install.
- Document installer code and existing zone map for takeover jobs.
- Plan antenna routing (ANT5XL) when panel location has poor cell RSSI.
- Have listed batteries and tools for sensor mounts before enrollment.
Typical install sequence
- Mount and power panel; apply firmware updates per dealer bulletin.
- Install cell module and run communication test / central station / Dealer Admin activation.
- Enroll wireless sensors via installer Learn mode; label zones.
- Include Z-Wave devices after excluding from any prior hub.
- Install 433 MHz expander or optimize receiver placement before fringe wireless sensors.
- Run walk test, user code training, and central station test if monitored.
Power and connectivity reference
| Product type | Power | Network / RF |
|---|---|---|
| DMP XR/XT/X1 panel | AC + backup battery | Keypad bus; LTE/IP communicators; 1100 Series wireless |
| Wireless sensor | Battery per SKU | 1100 Series 1100 Series; 433 MHz on Reliance NXG-433 |
| Cell module | Panel-powered | LTE to dealer / central station / Dealer Admin |
| RAS keypad | Data bus | DMP XR/Entré host |
| Z-Wave module | Mains or battery per device | Z-Wave to panel |
Source: DMP fire device installation guide (DMP official documentation).