Overview
2GIG Numera Fall Detection Pendant (F1) is listed here in the sensors category. For details, start with the manufacturer's own information.
Official information
FAQs
Why does my zone show trouble?
Most common: low battery, tamper open, out of range, or wrong sensor type for the panel receiver (345 MHz vs ePlus 900 MHz).
How do I replace a sensor?
Delete old zone in installer programming, enroll replacement using Learn mode, and test walk test at final location.
Will Alarm.com show this device?
When the panel has active interactive service, enrolled zones appear in the Alarm.com app with status matching the panel.
Where is official documentation?
- 2GIG product page
- 2GIG Full Catalog English
- 2GIG F1 fall detection pendant flyer
- 10023748a x3 installandprogrammingguide
- 2GIG Edge Smart Home Manual 1
- 2GIG Edge User Guide 1
- 2GIG GC2 User Guide
- 2GIG GC2 User Guide FR
- 2GIG GC2 User Guide PO
- 2GIG GC2 User Guide SP
Primary reference: 2GIG keyfob and panic device guide
How do I test after installation?
Use panel walk test, zone status, and (if monitored) central station test per dealer procedure.
Can I mix 345 MHz and ePlus sensors?
ePlus 900 MHz sensors require XCVR2 transceiver hardware — they do not enroll on the standard 345 MHz receiver alone.