DSC Multiple Wireless Receiver Module

The PC5320 is a multiple wireless receiver module for classic PowerSeries — it expands 433 MHz wireless zone capacity. DSC catalog lists it under communicators, but it is not a central-station communicator.

Reporting path

PowerSeries wireless receiver module

At a Glance

Before You Install or Replace One

• Confirm exact model number on the communicator label matches the install manual.

• Verify host panel family — Keybus PowerSeries, Neo Corbus, MAXSYS Combus, IMPASSA integrated, or universal dialer-capture are not interchangeable.

• Confirm monitoring receiver and account accept this communicator format (Contact ID, SIA, IP, cellular).

• Check carrier/network generation (3G sunset, LTE band, Ethernet path) for your region.

• Add communicator current draw to panel battery standby calculation where the module loads from panel bus power.

Official Sources

• Product page: DSC Multiple Wireless Receiver Module (ID 43)

• PC5320 v1.0 Installation Manual — DSC official documentation

PC5320 wireless receiver module

The PC5320 is a wireless receiver, not an alarm communicator. It receives RF from wireless sensors/keyfobs.

Panel FTC and alt-comms troubles apply to the host communicator, not this accessory — see the communicator listing for full trouble tables.

Source: PC5320 v1.0 Installation Manual (DSC official documentation).

PC5320 service

• Do not confuse with cellular communicators — PC5320 does not report to central station by itself.

• Pair with compatible PowerSeries wireless ecosystem per PC5320 install manual.

For panel reporting faults (FTC, alt-comms), troubleshoot the host communicator module paired with this product — not this accessory alone.

Source: PC5320 v1.0 Installation Manual.

This page lists which alarm panels and related equipment work with this communicator — not wireless sensors or keypads.

Host panels & systems

Related accessories

• 433 MHz PowerSeries wireless devices (WS/RF series)

Not compatible

• Neo PowerG receivers
• Cellular/IP reporting (use separate alt-comms module)
• MAXSYS PC4164 wireless receivers

Central station / receiver notes

Universal and T-Link products require a monitoring receiver that accepts the communicator's protocol and supervision. Confirm with your central station before install.

Source: PC5320 v1.0 Installation Manual (DSC official documentation).

Follow PC5320 v1.0 Installation Manual for wiring, mounting, enrollment, and receiver programming. Summary below — not a substitute for the full manual.

Pre-install checklist

• Match communicator SKU to host panel family (see compatible-peripherals.md).

• Plan mounting location — metal cabinets, underground rooms, and long coax runs affect cellular/IP performance.

• Reserve panel bus power or external power per manual; update battery calculation chart.

• Confirm monitoring account and receiver are provisioned before final test.

Typical install sequence

1. Mount communicator (or PCL-422 remote mount if used) per manual clearances.

1. Wire power and data: Corbus/Keybus homerun, dialer Tip/Ring, or Ethernet as applicable.

1. Enroll module in panel programming (Neo/Pro [902], PowerSeries alt-comms section, IMPASSA [382]/[401] as applicable).

1. Program reporting codes, account, and path priority (primary/backup for dual-path).

1. Register with central station / Alarm.com / T-Link receiver.

1. Run end-to-end communication test and document signal levels.

Regional notes

433 MHz PowerSeries wireless only

Source: PC5320 v1.0 Installation Manual (DSC official documentation).